A bit more elaboration on my previous question.
I am using the KAM+. This initializes and comes up every time under WIN98.
However, when I boot up with WIN2000 (same PC, dual boot OSs), the KAM will not
initialize. The Writlog.ini files are identical under 98 and 2000. Ports are
set to 4800 in both files and the KAM itself is set to 4800 baud.
However, if I boot up with WIN2000, then start the KAM with "PACTERM for
Windows" (a TNC program from KanTronics), then close the program, then start
Writelog, the KAM will initialize just fine. I can then close Writelog and
reopen it as many times as I want and it will initialize the KAM. However, if
I shut down the PC or reboot for any reason, then I am back to no
initialization.
PACTERM can be set to leave the KAM in either terminal or host mode upon
closing. I have tried it both ways, and it doesn't make a difference.
Port settings are at default levels in both 98 and 2000 in Device Manager.
Any advice appreciated.
Thanks,
Jim W4LC
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|