Hi all,
I've just installed WL10.45 in preparation for next weekends' FMRE RTTY
contest, and I found a problem!
If I use the NUMERIC keypad, all numbers except 1 work!
Whenever I press 1, it clears the entry window entirely, which is NOT good!
I tend to use that for entering serial numbers, especially when CQ'ing.
OK, I can use the top row of numbers, but that is not as easy.
I also had an oddity with the SHOW MULTS window. If I opened it, it showed
on the task bar, but wasn't visible. For some reason, it took several goes
at changing it in the INI file before I could get it to show.
It appears to have modified the INI file section to position this window at
X=3000 and Y=3000 !!!
Changing those vales to 300 worked.
Anyone got any bright ideas about the number 1 on the numeric keypad,
though, as I think this is important.
Cheers for now
Phil GU0SUP
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|