Bob
I've turned down the power of the Icom to .5w and still it happens
I know it sounds like RF feedback but I've almost that is possible to stop
it. I've just tried it on a dummy load and lo and behold it still happens
Ideas Bob??
-----Original Message-----
From: Bob Naumann - N5NJ [mailto:n5nj@gte.net]
Sent: 12 February 2004 15:24
To: Nick Kail; writelog@contesting.com
Subject: Re: [WriteLog] Problem with MicroHam USB Interface
Does this only happen with RF present?
What happens if you turn down your output power?
> ------------Original Message------------
> From: "Nick Kail" <m3mlr@tiscali.co.uk>
> To: <writelog@contesting.com>
> Date: Thu, Feb-12-2004 9:12 AM
> Subject: [WriteLog] Problem with MicroHam USB Interface
>
> Can anyone help me on this Just started playing with this interface and
the
> CAT side is good but when I start using it for CW at the end of the over
it
> doesn't lock into Receive but flashes from rx to tx for about 5 seconds
> which means I've lost the first part of the exchange. I added torroids to
> the leads and short of putting it and the pc in a different room have move
> the two apart.
>
>
>
> Tnx
>
>
>
> Nick
>
> 2E0MLR
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|