Up until a couple of weeks ago I had it all set up nicely ( Com1 rigblaster
modified for FSK Com2 Microham USB for CAT and CW) then after a drive crash
carried out a reinstall and now when I go through the setup on the ports and
now can't get com2 to hold the configuration plus once I set it up ( rig
ic-746 baud same as rig no polling and no PTT ) the rig goes into perminate
Tx mode. This happens on both RTTY and CW. Any help would be greatly
appreciated as I have missed two contests this weekend already :-((
Cheers n Beers
Nick
G3VCP
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|