Re: [WriteLog] Help with IARU setup

[George Johnson <w1zt@comcast.net>]

Michael,
I just can't pass this one up...  did you want his zone entered before or 
after he sent it?  :-))  The tab or spacebar seems to do it here but I do 
recommend you copy what is sent just to make sure the guy didn't do 
something strange...

The red line in the BandMap identifies the RTTY SubBand of the band being 
displayed.  You can change it by editing / specifying things in the program 
Edit sub-bands located in your programs folder.  See the Help file under 
Band Map / Band Edges.

For the beam headings, look in the Great Circle section of Setup.  Look for 
the tab "Layout" to see if you have selected all of the items you 
wanted.  You can select and position the entries as you would like.
73 and good luck,
See you in IARU,
George .. W1ZT




At 03:03 PM 7/7/2004, WG0M@aol.com wrote:
> Hello All;
> I am new to WL, but am making headway.  I have a few questions:
>
> Beam heading is wrong.  It shows LP and Reverse only.  I have entered the
> correct data in Great Circle data window.
>
> Getting ready for IARU (CW), I have enabled the "Enter sends exch/QRZ". I
> noticed that if I enter a call and hit either Insert or Enter, it doesn't 
> fill
> the IARU zone.  It will fill if I hit tab.  Is there any way to get the zone
> entered at the same time of the exchange is sent?
>
> On the Bandmap on side of the green vertical line is a red line.  What does
> that represent?
>
> That is it for now.  Thank you in advance
>
>
>
> 73's
>
> Michael WG0M


_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/