To: | writelog@contesting.com |
---|---|
Subject: | [WriteLog] CW keying w/Mark V Field |
From: | Kelly Jones <kjones@sullivan1.com> |
Date: | Fri, 26 Nov 2004 11:11:23 -0700 |
List-post: | <mailto:writelog@contesting.com> |
Hello fellow WL users, I have an issue that I'm sure is an easy fix, but looking through the archives I've not found an answer. Our group has decided to try CQWW this weekend and use WL as the CW keyer. We will be using a 1000 Mark V Field as the rig. The serial interface is built and seems to be polling the rig for freq just fine. However, the issue we are having is that the rig keys fine for the first character of a letter, then goes back into RX. For instance, the rig keys, sends a "dit" or "dah", then returns to RX and continues sending the rest of the 'message'. I found a couple other posting stating the same problem, but never saw any resolution. In the setup I have the following checked/set: Under Ports: CW on COM1, Rig Type = Yaesu FT-1KMP Baud Rate = Auto Poll = checked Comm PTT = Sync (had it to Yes but didn't make any difference) All Mode PTT on CW port RTS = checked CW Keyer type = PC generates Under CW PTT: Command rig on COM port = checked I have fiddled with the PTT to CW delay. This seems to key the rig for the amount of time I put in there before it starts sending any CW, but again, after the first character it puts the rig back in to RX. WL version = 10.48F. If I use the VOX, I can run in QSK mode, but I don't want to do that. Shouldn't the rig stay keyed until the 'message' has finished sending? Thanks for any help in the 11th hour! 73 Kelly - N0VD
|
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [WriteLog] LPT Port and BCD Signals, Richard Thorne |
---|---|
Next by Date: | Re: [WriteLog] .wav file ID for (?) ???, Gary Senesac AL9A |
Previous by Thread: | [WriteLog] LPT Port and BCD Signals, Richard Thorne |
Next by Thread: | RE: [WriteLog] CW keying w/Mark V Field, Kelly Jones |
Indexes: | [Date] [Thread] [Top] [All Lists] |