Help!
I have what appears to be an interface problem with WriteLog 10.42.
I have been using WriteLog for logging and keying the transmitter with
memory messages. I have not used it for rig control. I simply ran
the DTR line from the serial port into the base of a transistor and
used that to key the rig. My operating system was Windows NT and this
all worked fine.
Recently I changed the operating system to Windows 2K and reloaded
WriteLog. Now there is no way I can get the computer to key the
transmitter with the memory messages. Very frustrating considering
that I want to use it for the ARRL 160 contest tomorrow night! I have
not made any hardware changes.
I have noticed one thing. In the port setup window, if I check either
CW or rig on the line associated with COM2 and press enter, the
transmitter is keyed continuously. I have to go back into the port
setup window and uncheck the setting before I can stop it.
Any suggestions? Panic is rising here!
73, Rudy Severns N6LF rudys@ordata.com
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|