Rick,
Not much help (it is too early in morning for brain to wake up) but I see
that I have a "special" cable I make to take my Heil Icom mic to the sound
card. There is something you have to do. After I did the cable, mine worked
much much better than the older "comm" element with the external mic preamp
i built.
I will look for notes today. But just thinking about it, you have to get
the dc voltage to the mic on the single mono wire - so my guess is: the
mono wire goes to the ring end of the stereo plug and a small cap goes from
ring to tip.
Jerry, W6IHG
PS Found my notes that say -
- has a special adapter cable for the radio because the DC (7.0 volts)
feeds thru to the microphone element.
- on the sound board there is 3.6 volts on the "ring"
- Need to wire an adapter cable for use with the new headset and the computer.
At 10:56 PM 10/3/2005 -0400, Rick Mintz wrote:
>Hi guys,
>
>A question on recording voice .WAV files.
>
>I am using a Heil "ic" element and seem to have a VERY low level audio
>going to Windows sound recorder. Anyone have a solution?
>
>
>Rick W1TY
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
>WriteLog on the web: http://www.writelog.com/
------------------------------------------
Dr. Jerry R. Pixton, PIXOS Designs LLC
http://www.pixos.com/designs/RadioTuner/
jpixton@shentel.net
------------------------------------------
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|