I found the problem why I could not send SSB macros with writelog using the
rigblaster plus
We should nevr forget to configure thaht way
in setup port section
In dvk type....windows soundboard
In cq keyer type highlight....pc generate
in cw ptt......on lpt pin16/comm rts
wishing that article usefull for someone
Gilles ve2lx
===========
THE PROBLEM WAS FOUND BY RIGBLASTER OWNER......?
FROM WRITELOG I RECEIVED AN UNACCEPTABLE ANSWER AND AS USUAL AS SHORT AS
POSSIBLE, THAT BESIDE ALWAYS GONE
================================================================
----- Original Message -----
From: ve2lx
To: WL posting
Sent: Tuesday, March 07, 2006 5:45 PM
Subject: ssb wave no ptt and no tx
Is anyone can tell me where is my error
I use a rigblaster plus and ocnfigure ssb macros.
I ear them in radio spaeaker but no ptt and tx...?
I shown to WL where are the macros.
in receive it identify correctly bands via ct-17 interface.
I configured setup DVK (windows soundboard)
But if I configure com port as for my icom ic 765 the radio then stays in
transmit position.
Is anyone has experimented that situation in SSB operation......?
Gilles ve2lx
============
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|