I think that may be the problem.
I can not find any setting on the RADIO to change the stop bits.
I can only change the Baud between 4800, 9600
There is no place to change bits on the radio menu or in manual.
In the writelog, I can only find a Baud rate setting, Auto, 4800, 9600, etc.
There is no place to set Bits on the application writelog, that I can find.
I think my communications link comes up, and then crashes because of the
wrong bits. And that is why I keep getting bumped into Split mode because
the bits are out of sync.
Miles
Brazil is getting too close.
-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com] On Behalf Of Jim Reisert AD1C
Sent: Tuesday, June 27, 2006 3:51 PM
To: writelog@contesting.com
Subject: Re: [WriteLog] Anyone using FT9000 with Writelog?
I know the FT1000 series of radios require 2 stop bits.
Is the FT9000 configured like this?
73 - Jim AD1C
--
Jim Reisert AD1C, 7 Charlemont Court, North Chelmsford, MA 01863
USA +978-251-9933, <jjreisert@alum.mit.edu>, http://www.ad1c.us
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|