>From the Writelog Help Manual under [PORTS]:
There are 4 "slots" available for WriteLog rig interfacing. By default,
CommSlot1 is COM1:, but you can change that by changing the number on the
right of the equal sign. These settings are not used for RTTY or for packet
CommSlot1=1
CommSlot2=2
In this example, the third and fourth slots are on COM7 and COM8. COM15 is
as high as is supported.
CommSlot3=7
CommSlot4=8
Add the above CommSlot= lines to the [PORTS] section of your writelog.ini
file.Gary AL9A----- Original Message -----
From: "Joseph Young" <jwyoung@cybertrails.com>
To: <writelog@contesting.com>
Sent: September 28, 2006 12:17 PM
Subject: [WriteLog] Setting Up WinKey
>I want to setup WinKey with WriteLog. I have available COM ports 7
> and 8.
> Writelog offers COM ports 1 through 4 for CW assignment.
> How do I get around this?
> Thanks and 73 de Joe/W6RLL
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|