Thanks to those here, and off list who pointed me to the
[Rigs] section. Of course I had also forgotten that the data
is NOT automatically copied from the ports set up, and one
has to enter the data oneself (e.g. to change an ICOM
ADDRESS), making certain that the name of the relevant rig
is EXACTLY as in the ports section, down to case
sensitivity.
Like Steve, I'd also like to know if there will be updates
any time soon, particularly in the area of support for the
MK2R+?
73
Clive
GW3NJW
-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com]On Behalf Of Clive
Whelan
Sent: 27 December 2006 10:37
To: writelog@contesting.com
Subject: [WriteLog] ICOM addresses
I thought that the ICOM address ( if any) was somewhere in
the .ini file, and could be modified to override the
selection in the ports dialog. However I can't seem to find
it now. Did I imagine this, or is it perhaps the effect of a
surfeit of Xmas pudding?
73
Clive
GW3NJW
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|