See the free compass rose antenna module for Writelog
It free from Keith Regli, www.regli.com.
I place it amoung the other Writelog windows, it controls any rotator you
can normally control via Writelog.
On 11/27/2007 9:22:13 PM, Jim McDonald (jim@n7us.net) wrote:
> I wanted to stop the rotor before it reached the desired bearing but found
> I
> couldn't when using the controller. DXbase does have a rotor stop
> command,
> which is what I'd
> like to see, as well as the long path.
>
> I have a Yaesu rotor with the Idiom Press board. It can rotate 450
> degrees,
> and the extra 90 degrees from south to west is handy. It would be
> nice if
> the program knew that.
>
> Jim N7US
>
>
>
> -----Original Message-----
>
>
> Also Rick,
>
> In my set-up, the first rotor is physically off north and I have to
> correct
> it in the .ini file. The second rotor is fine, but I have not found
> a way to
> do the correction independently (still looking).
>
> In the future some sort of radio to rotor mapping may be of use to me as
> I
> am considering a 40 meter dipole or beam on a separate rotor.
>
> 73 Eric - VE3GSI
>
>
>
> > -----Original Message-----
> > From: Rick Tavan N6XI
> >
> > I use "Antenna to [nnn] Azimuth" a lot. It would be very nice
> > to have a companion function that turns the antenna to the
> > long-path bearing (+/- 180) which is cu
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|