I seem to remember seeing the answer to this awhile back too. Try going to
Setup/Ports and click on Wav File Locate... Select any wav file from your
location and then click OK. Despite the location being in the ini file I
think WL has lost the path to the wav files. Then before exiting click on
both Setup/Save Configuration and File/Save just to make sure the location
is really saved. Restart WL and see if it works. GL OM.
73,
Gary AL9A
----- Original Message -----
From: "K8FC" <k8fc@k8fc.com>
To: <writelog@contesting.com>
Sent: December 28, 2007 8:27 PM
Subject: [WriteLog] Cant set wave fie to XXXX
>I know I have seen some answers to this before but they indicate you have
>to have a file in a designated folder. I do and that is not the answer.
>The wavefile location is setup in the WL ini and this message comes up
>every time you load WL no matter where your wave files are located. What
>is this error message really looking for ?
>
> Thanks in advance,
>
> Joe
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|