Hi Steve,
By default with no configuration changes or Mouse_Click_HZ entry I get 10 Hz
per on my Icom P3 for CW.
With the 10.68F version I use, I cannot MOUSE_WHEEL_HZ=3 to work, in fact I
never remembered a number less than 10 working for me, everything from the
number 10 up is fine. The number 10 does indeed give me 10 Hz, 30 gives me
thirty Hz and so on.
I checked TS (Tuning speed) on the rig and changes there do not matter
either.
Not sure if it possible to change the way WL works this way, but could you
have the mouse driver set to more than the default number of lines per
click? I am using a MS mouse driver and it does not support a lines per
click change, but I have seen mouse drivers that do allow the number of
lines per click to be changed.
Good Luck,
Eric - VE3GSI
-----Original Message-----
From: k4fj@aol.com
Subject: [WriteLog] Mouse Wheel question
I like to use the mouse wheel to tune cw and data modes.? I have noted
something strange and need a head check.
In the Writelog.ini file, under Configuration, I have entered
Mouse_Wheel_Hz=3, but I am seeing 30 Hz change for each mouse wheel detent.?
If I change the ini setting to =30, I get 300 Hz change per detent.? I have
not found a way to get 3 Hz per detent.? I can live with 30 Hz but would
like less.
Anyone else seeing this?? I am using the latest WL 10.68 and it was the same
with 10.67.
73, Steve, K4FJ
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|