Thanks to everyone who replied. Apparently I cannot type what I see :-(
Added a second " M " to ComSlot and it worked fine. Everything is now working
and I only need to update some files.
Appreciate the help on such short notice.
/lee
---------- Original Message ----------------------------------
From: "Richard L. King" <k5na@ecpi.com>
Date: Wed, 26 Nov 2008 15:02:50 +0000
>The syntax is:
>
>CommSlot2=6
>
>Use 2 Ms and it should work.
>
>73, Richard - K5NA
>
>
>At 14:59 11/26/2008, signup wrote:
>>Hi,
>>
>>Under [Ports] I added the following statements:
>>
>>ComSlot1=1
>>ComSlot2=6
>>ComSlot3=7
>>ComSlot4=8
>>
>>The problem is, when I open WriteLog and go to Setup and ports, what
>>I see is still Com 1, Com 2, Com 3, and Com 4. Its as I am not
>>writing to the correct Writelog.ini; however, I see that the rig
>>information for the Yaesu on Com 1 is clearly in the .ini file.
>>
>>Any suggestions, I have done this in the past and it worked fine, so
>>I am confused?
>>
>>/lee K5UN / TO5X
>>
>>
>>
>>
>>
>>________________________________________________________________
>>Sent via the WebMail system at k1nt.com
>>
>>
>>
>>
>>_______________________________________________
>>WriteLog mailing list
>>WriteLog@contesting.com
>>http://lists.contesting.com/mailman/listinfo/writelog
>>WriteLog on the web: http://www.writelog.com/
>
>
________________________________________________________________
Sent via the WebMail system at k1nt.com
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|