Hello to all,
I sent a email about a week ago asking about the CW display. Gary, AL9A, was
kind enough to provide an answer. Thanks Gary!
My new problem is this: when I set up the CW/RTTY/SSB Memory Setup window, I
type in %3 so that my sequence will be sent in a three digit format. The
instructions in the WriteLog Manuals say that "T" will be sent for "0" (zero).
However, my program sends "0" NOT "T" This makes a big difference in CW
contesting.
The manual states that "if the mode is CW, the digits are translated to letters
according to the [Cut-Numbers] section in WRITELOG.INI." When I go to the
[Cut-Number] instructions of the manual, it shows a table that says that 0 will
be sent as 0 if "you don't set up this section." The manual states that the
WriteLog.ini file is in ASCII and is "directly editable."
I have not been able to discover how to set up the [Cut-Number] section of the
WriteLog.ini file to send T for zero. I haven't even been able to find the
[Cut-Number] section in the .ini file.
Help? Anyone!
73,
Ed WB8TSD
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|