Ed,
The cut number section looks like this
[Cut-Numbers]
0=T
1=1
2=2
3=3
4=4
5=5
6=6
7=7
8=8
9=N
Mine follows the [Ports] section but that may not be critical.
73,
Don VE3XD
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com] On Behalf Of Edward Taylor
> Sent: September-23-09 7:47 AM
> To: WriteLog@contesting.com
> Subject: [WriteLog] CW number setup
>
> Hello to all,
>
> I sent a email about a week ago asking about the CW display.
> Gary, AL9A, was kind enough to provide an answer. Thanks Gary!
>
> My new problem is this: when I set up the CW/RTTY/SSB Memory
> Setup window, I type in %3 so that my sequence will be sent
> in a three digit format. The instructions in the WriteLog
> Manuals say that "T" will be sent for "0" (zero). However,
> my program sends "0" NOT "T" This makes a big difference in
> CW contesting.
>
> The manual states that "if the mode is CW, the digits are
> translated to letters according to the [Cut-Numbers] section
> in WRITELOG.INI." When I go to the [Cut-Number] instructions
> of the manual, it shows a table that says that 0 will be sent
> as 0 if "you don't set up this section." The manual states
> that the WriteLog.ini file is in ASCII and is "directly editable."
>
> I have not been able to discover how to set up the
> [Cut-Number] section of the WriteLog.ini file to send T for
> zero. I haven't even been able to find the [Cut-Number]
> section in the .ini file.
>
> Help? Anyone!
>
> 73,
> Ed WB8TSD
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|