> I am using a Vscomm 2 port PCI interface. This has always worked for
> me in the past. No change to hardware config.
>
> I am running FSK.
You have five options for PTT (in order of best to worst):
1) connect a PTT interface (resistor/transistor) to the RTS (or DTR)
line of the FSK port
2) leave the WinKey connected/configured and use the PTT line from
WinKey ("All mode PTT on RTS" is forced with WinKey)
3) add a CW and PTT resistor/transistor interface on an unused port
and check "all mode PTT on RTS"
4) assign "PC Generates" CW to the same port as rig control, connect
a PTT interface to RTS on the rig port and check "All mode PTT on
RTS')
or
5) set "Comm PTT" to YES if your rig supports PTT via software command.
73,
... Joe, W4TV
On 8/21/2010 5:51 PM, Dave Earnest wrote:
>
> I am using a Vscomm 2 port PCI interface. This has always worked for
> me in the past. No change to hardware config.
>
> I am running FSK.
>
> I do not have CW selected, but when I use CW I use the Winkeyer 2,
> and have it on Comport 5.
>
> I am running Vista, 64 bit version OS.
>
> 73,
>
>
> Dave Earnest
>
> k7jj@arrl.net
>
>
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|