Try:
Tools
Sound Board Options
check: Echo Microphone
Good Luck,
Jim
Chuck wrote:
>I just got the RigExpert TI-5 and can't figure out how to get audio through it
>from the mic plugged into the back of the TI-5 to the rig. CW and CAT
>functions are ok. It will record off the air. The instructions say: "In the
>sound card software, select the USB Audio Codec sound card." When I go into
>Control Panel, Hardware and Sound, Sound I have a record and playback buttons
>which both show USB Audio CODEC working. I have set the Writelog sound manager
>to USB Codec. I get no audio from the mic to the rig. I am hoping to make this
>work with Writelog as a DVK. What am I missing? I don't have to use the foot
>switch, do I?
>
>Thanks!
>
>Chuck W5PR
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
>WriteLog on the web: http://www.writelog.com/
>
>
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|