Confusing question. You can change a lot of Icom radio's to whatever
port you want in the respective menu. Thus you could have 2 706Mk2G's
one at 58 and one at 42 if you want. So it would depend. The address
00 hex hits every address on hte CIV at once. Or if you don't know what
address it is on that will work for anything on the bus.
The purpose of hte CIV unit is to address more than one and as long as
you specify in writelog the address that should be okay.
Search in Writelog help for icom radio for some examples.
/The COMn_RTS_INIT and COMn_DTR_INIT settings are for the ports used for
rig control (only--not FSK or any other COM port uses) and change the
way WriteLog initializes the RTS and DTR lines on the rig port. Setting
the value to 0 (zero) causes WriteLog to initialize the line off.
Setting the value to 1 (one) causes WriteLog to initialize the line on
(which is the default if there is no entry). Setting the value to
anything else, like -1 (minus one), causes WriteLog to not change the port.
WriteLog supports RTS/CTS flow control for some rig drivers that turn
that feature on, and that feature is disabled if COM_n_RTS_INIT is set
to 0, 1 or -1, but is enabled for a setting of -2./
|COM1_RTS_INIT=-2
COM1_DTR_INIT=1
|
/The following entries override WriteLog's default setting for the Icom
rig address for the various Icom rigs. All rigs that have Icom rig
addresses have corresponding entries in WriteLog.ini here under the name
that matches the name in the Setup Ports dialog *including space
characters*!/
|Icom IC-781=0x33
Icom IC-756PRO=0x12
|
/For WriteLog to talk to the Kachina front panel software, it must know
where the Kachina software is installed./
On 3/22/2012 11:53 AM, Andre VanWyk wrote:
> Does anyone out there know of a way to use an Icom CT-17 CIV unit (with
> multiple radios connected to it) with Writelog.
> Since there is no way to be able to assign the same com port number to both
> radios, I would guess this is impossible, but there might be some virtual
> comport / bridging software out there?
> Any help would be appreciated.
>
> 73
> Andre NJ0F
> _______________________________________________
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|