Dick,
When you say everything has been running pretty good, does that mean you
used to get stuff in the band map or not? You don't mention a DX cluster in
your note. Which cluster are you connecting to? Are you using telnet?
When you open the Incoming-only Packet window what does it say for a Telnet
address and a Port number? Need more info to figure out where the problem
is. Running V11.04A here and the Incoming-only Packet works FB - it should
on your V11.02B too.
73,
Gary AL9A
----- Original Message -----
From: "DickT-W0RAA" <dickt@w0raa.com>
To: "Writelog Reflector" <writelog@contesting.com>
Sent: May 21, 2012 5:54 PM
Subject: [WriteLog] Band Map Problems
> Hi guys,
>
> I'm running WriteLog 11.02B and up until recently, everything has been
> pretty good. Well, during a recent contest, I brought up the Incoming
> Only
> Packet Window, logged in, and was hoping to see some spots in the
> Bandmap window.
>
> Well, nothing appeared, and it still isn't working. I'm not sure where to
> look
> next. I usually operate non-assisted, but I wanted to see if there was
> any
> DX or
> mutipliers that I could use. I just can't get anything to appear in the
> Bandmap
> window.
>
> Can somebody (hopefully) point me in the right direction to see if I can
> start
> getting spots to show up in the Bandmap window. Any assistance will be
> appreciated.
>
> 73,
>
> Dick - W0RAA
> w0raa[at]arrl.net
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|