If necessary, you could probably use whatever works as the prime
decoder (and tx from that one), then ser up 2tone in a clone window
and use it in rx mode only.
Jerry W4UK
At 04:35 PM 9/18/2013, Gary AL9A wrote:
I just finished setting up WL for the BARTG Sprint 75 contest next
Sunday. Before starting the setup I check the rttycontesting.com
web site and found that there was a new version of 2Tone, 13.09b,
available for download. My version was 13.04a so I downloaded it,
unzipped it and think I have it correctly located. When setting up
WL my clone window for 2Tone works ok and the Help button shows the
version as 13.09b as I expected.
However, I notice when sending test messages to my dummy load the
text printing to the 2Tone clone screen is sometimes correct,
sometimes partially garbled. Is this normal with version 13.09b or
is it the 75 baud speed? Anybody tried receiving off the air at 75
baud with this version of 2Tone yet? Will there be a pre-contest
warm up period to check macros, settings, reception, etc. before
next Sunday? Would like to make sure this latest version is working
correctly before then.
73,
Gary AL9A
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|