As *always* check the sound card selections in WriteLog's "Sound board
mixer control" and the Windows "Recording Devices" settings for "Line
(microHAM CODEC)" in Windows Sound Control Panel.
Of course, make sure the audio cable is connected to your transceiver
(AF Out in the case of the FT-1000MP).
73,
... Joe, W4TV
On 12/29/2013 6:54 PM, W7OM@aol.com wrote:
WL to microHam Keyer II to FT-1000MP with Windows 7 64 bit machine.
CW Display (Left) is dead. No change to WL or machine. Did not make any
software selections other than normal selection of a contest module.
Any suggestions?
73 and the best in 2014,
Rod W7OM
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|