WriteLog
[Top] [All Lists]

Re: [WriteLog] GRITTY working with WL?

To: 'Gary AL9A' <al9a@mtaonline.net>, Ed Muns <ed@w0yk.com>
Subject: Re: [WriteLog] GRITTY working with WL?
From: Carsten Steinhoefel <carsten@steinhoefel.co.uk>
Date: Fri, 10 Apr 2015 15:33:54 +0000
List-post: <writelog@contesting.com">mailto:writelog@contesting.com>
I suspect it is not finding the signal because of the tones set up. I had to 
click on the left screen (waterfall) to tell it where to receive. The little 
red and blue arrow move there then, too.

73 Carsten G0SYP

________________________________________
From: WriteLog <writelog-bounces@contesting.com> on behalf of Ed Muns 
<ed@w0yk.com>
Sent: 10 April 2015 16:07
To: 'Gary AL9A'
Cc: 'WriteLog Reflector'
Subject: Re: [WriteLog] GRITTY working with WL?

What IF bandwidth selections are available in RTTY/FSK mode on your radio,
Gary?  The K3 allows any bandwidth, continuously variable up to 3 kHz.  The
issue is not AFSK vs. FSK (which is just the transmission method) but rather
the receiver IF bandwidth.

It could be that it requires a 3 kHz bandwidth since it is a component for
RTTY Skimmer.  If so, I'm not sure how useful it will be for a RTTY
contesting decoder.  It is unlikely I would run GRITTY alone and I need a
500 Hz IF bandwidth for my other decoders.

The N1MM Logger Plus team has interfaced GRITTY and it should be out in a
future release.  I guess we'll hear from them as to its merits.  I don't
think much can be evaluated until GRITTY can run side-by-side with MMTTY and
2Tone over many hours of contesting.

Even when 2Tone was initially available with WriteLog, my first impression
was that it was "superior" to MMTTY.  But, now after hundreds of intense
contesting hours, running MMTTY, 2Tone and the DXP38 in parallel on the same
signal, I'm convinced that each decoder has its superior moments when the
other decoders don't print anything useful.  There are certain conditions
where one decoder works and the others don't.  If you only experience that
certain condition, it is easy to infer that the decoder is superior in all
conditions.

Ed W0YK

-----Original Message-----
From: WriteLog [mailto:writelog-bounces@contesting.com] On Behalf Of Gary
AL9A
Sent: 09 April, 2015 23:07
To: WriteLog Reflector
Subject: Re: [WriteLog] GRITTY working with WL?

I've downloaded Gritty but haven't had much time to play with it yet.  Can
someone enlighten me a bit?  Does it only work for AFSK?  If I set my
IC-7600 to LSB I can get an occasional call sign to show, but if I put the
radio into RTTY for FSK it appears the band width is too narrow for Gritty
to decode.  Or am I off the Mark here?

73,
Gary AL9A


-----Original Message-----
From: Ed Muns
Sent: April 09, 2015 7:48 PM
To: 'Jerry Flanders'
Cc: WRITELOG@contesting.com
Subject: Re: [WriteLog] GRITTY working with WL?

Currently, GRITTY is a standalone decoder.  The most obvious way to
integrate it instantly with several loggers is to interface it to xmmt.ocx
which is what WriteLog, N1MM Logger, DXlabs and several others use to
integrate MMTTY, MMVARI and 2Tone.

Ed W0YK

______________________________________________________________

Jerry W4UK wrote:

Anybody got Alex's new RTTY demodulator working with Writelog?

See: <http://dxatlas.com/Gritty/>http://dxatlas.com/Gritty/

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please visit http://www.symanteccloud.com
______________________________________________________________________

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please visit http://www.symanteccloud.com
______________________________________________________________________
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>