GM Keith
I noticed the same situation also. My rig a FT 1000 Mark 5.
Writelog ver 12.35c.
OBTW congrats on beating me again in IARU. It has been a few
years, since I last beat you,
so next year watch out. Hi Hi.
73 BoB WA1FCN
On 7/14/2019 4:57 PM, Keith Beebe W3KB wrote:
For whatever reason my rig, using Writelog in the recent IARU HF Championship
contest, goes to LSB on 160 meters instead of CW when clicking on a spot in the
Band Map. I was operating only on CW, not Mixed mode (CW and SSB) in this
contest therefore obviously clicking only in the CW frequencies on 160.
NOTE: All of the other bands 80 through 10 meters worked perfectly clicking on
the CW spots from the Reverse Beacon Network. The rig stayed on CW on those
bands.
For another reference, I just tested putting a frequency, say 1835, in the
Entry Window itself and it does the same thing. The rig goes to LSB instead of
CW.
However, if I click the box to the left of the Entry Window it opens to the
settings for Logging / Duping. Putting a frequency, say 1825 on CW in that
particular window and the rig goes to CW like it should.
Go back to the Entry Window and put in a 160 meter frequency it will go to LSB
not CW ! Clicking on a 160 spot in the Band Map will also make it go to LSB
not CW.
Why is only 160 meters having this issue?
Again, this is only the IARU HF contest "module" doing this and only on 160
meters. Yes, I also tried a few other modules (such as the one for the CWT's) and 160 CW
works perfectly.
Keith W3KB
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|