Does the transceiver show "A" as the operating mode on the display
or does it show MT? Make sure you are in VFO mode and not memory
or memory tune.
73,
... Joe, W4TV
On 2021-07-25 9:38 AM, Jim Johnson wrote:
No sir! I don't think it is, because I can spin the dial and the frequency
changes on the radio but not WL. Actually, it is fully functional with another
logging program.
----- Original Message -----
From: Keith Beebe W3KB <keith@w3kb.net>
To: Jim Johnson <jim@kc4hw.com>, <writelog@contesting.com>
Sent: 7/25/2021 7:30:57 AM
Subject: Re: [WriteLog] FT-891 Setup in Writelog
________________________________________________________________________________
Is it possible you have the dial "locked" on the rig itself? Unlock it, if it
is.
I had that happen to me before.
Keith W3KB
-----Original Message-----
From: WriteLog <writelog-bounces@contesting.com> On Behalf Of Jim Johnson
Sent: Saturday, July 24, 2021 11:24 PM
To: writelog@contesting.com
Subject: [WriteLog] FT-891 Setup in Writelog
I am having some trouble setting up the rig control for a FT-891 using Writelog
12.59F.
I selected FT-991 from the Rig Type and the enhanced port on my laptop which is
Com7, baud rate 19200 that matches the radio menu setting, poll checked and
Comm PTT NO.
I can enter a frequency in the QSO entry window and it will move the radio to
that frequency and display the frenquency properly. But turning the VFO know
does not have any effect on the displayed frequency.
Anybody, have any suggestion for this?
Jim/KC4HW
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|