When you first go into Writelog on the right hand side you can EXPORT
the INI file.
Two things.
1. The USB Cable must be very short -- this is an Icom problem.
2. In the [RIGS] section
Com3:=19200,n,8,2 Com port that you are using BUT 2 Stop
bits.
On 9/8/2022 3:03 PM, k3sk@buckwalter.co wrote:
HELP !!! VHF Contest is only 1-1/2 days away and I can't get my IC-9700 to
stay connected to Writelog. I had version 12.6 and it wouldn't work, so I
purchased the latest (v12.66) and it still don't work.
When I configure the port settings in WL it connects, and the radio's
frequency and mode are displayed at the QSO entry window and follow manual
radio tuning as it should. But after about 10 seconds, the QSO Entry window
changes to "No Rig". I've tried several different baud rates with no
difference in the issue.
The radio is set to the default address, A2H and I don't see where I can
check or change that in WL.
de K3SK FM07
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|