Hello Spiros
Here are my settings for connecting MkV to MMTTY and also N1MMLogger
program. I would go back to basics and just connect the MkV to the PC with
a three wire serial cable. Disconnect everything else until this is working.
In MMTTY Set up serial coms for MkV in this way
Option-Set up MMTTY-TX-Radio Command
Port select correct com port - use three wire cable TX-RX- GND
baud 4800 8 bits 2 stop bits no parity
Do not check any other boxes on top half of screen
select VFO polling FT-1000MP
frequency offset off polling intervil 0.5 seconds
Very bottom box is Yaesu HF (FT-1000MP)
Click ok to accept this
I use FSK keying and set up the PTT com port in the TX window for whatever
com port I am using for FSK.
The two common problems for this set up not working are
wrong number of stop/data bits for the MP and wrong cable connections.
I hope this helps please fell free to email me if you need more information.
73
Jim MM0BQI
----- Original Message -----
From: "spk" <spk@hol.gr>
To: <yaesu@contesting.com>
Sent: Thursday, January 02, 2003 11:40 PM
Subject: [Yaesu] Mark V and CAT
Hi,
I HAVE A PROBLEM WITH CAT OF MY NEW FT-1000 MK5. I bought it NEW from local
dealer. When I connect the rig to my PC to control it via a program
(MMTTY.commcat TRXMANAGER etc) the ring not response (I have PC's). When I
connect my lampic key paddle to radio and hold down dit or dah (in amy mode
SSB,USB,CW etc) the rig work and a connection with my pc happens.Any help me
to solve this problem???
Spiros - SV1DPP
spk@hol.gr
--- StripMime Report -- processed MIME parts ---
multipart/alternative
text/plain (text body -- kept)
text/html
---
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|