Yaesu
[Top] [All Lists]

Re: [Yaesu] Coupling the FT2000 to a notebook computer

To: Leland Vandervort <g0szp@g0szp.net>
Subject: Re: [Yaesu] Coupling the FT2000 to a notebook computer
From: Leland Vandervort <g0szp@g0szp.net>
Date: Tue, 16 Mar 2010 07:52:36 +0100
List-post: <yaesu@contesting.com">mailto:yaesu@contesting.com>
there are a few variants on that page which are optimised for various modes ;)

73

Leland


On 16 Mar 2010, at 07:51, Leland Vandervort wrote:

> 
> The RTTY interfaces often tend to be very low impedence and risk overloading 
> by plugging a sound card audio output directly to it.
> 
> There is a useful schematic at the link below for interfacing a sound card to 
> the mic or aux input, and includes RS232 control of the PTT.
> 
> Shopping list consists of a 470ohm, 8ohm, and 4.7ohm resistor, a diode, and 
> an NPN transistor.
> 
> 
> http://www.iw5edi.com/ham-radio-reference/sound-card-interfacing-for-rtty-psk31-and-sstv
> 
> 73
> 
> Leland
> g0szp/aa2qx
> 
> 
> 
> On 16 Mar 2010, at 02:33, Claude Frantz wrote:
> 
>> Hello Folk !
>> 
>> Do you have any experience about the coupling of the FT2000 to a 
>> notebook computer having only an audio out and a mike in jack ? I think 
>> the RTTY jack is the prefered way. Right ? Are the impededance and the 
>> level OK for a direct coupling or is any attenuator or amplificator 
>> necessary ?
>> 
>> Thanks a lot !
>> 
>> Claude
>> 
>> _______________________________________________
>> Yaesu mailing list
>> Yaesu@contesting.com
>> http://lists.contesting.com/mailman/listinfo/yaesu
> 
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu

_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu

<Prev in Thread] Current Thread [Next in Thread>