This probably is connected with the possibility of using switching mode
power supply on the filament xmfr's place. There are a lot of such
transformers manufactured for feeding 12 volt halogen bulbs rated from 50 to
200 watts. They are small, light and cheap. The RFI is under question.
Val LZ1VB
----- Original Message -----
From: "Steve Thompson" <g8gsq@eltac.co.uk>
To: <amps@contesting.com>
Sent: Thursday, July 13, 2006 5:37 PM
Subject: [Amps] High frequency heater supplies
> Does anyone know if there are problems using high frequency (say 30kHz)
> ac to run the heater in a valve with a cathode? For that matter, the
> filament in a valve without a cathode?
>
> Thanks,
>
> Steve
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|