John,
I don't think line voltage would amount to much, maybe 50-60 VDC more if there
was a 5 VAC raise on the
line. I don't think that's enough to get 200 more watts. My guess is the
wattmeters some use are a little loose.
I've seen this many times where they were off this much.
Best,
Will
*********** REPLY SEPARATOR ***********
On 7/17/06 at 11:12 AM John T. M. Lyles wrote:
>>I've never seen a pair of 3-500Z's driven with 100 watts
>>produce 1500W PEP ***on an accurate power meter*** with only
>>3000V on the anode.
>
>>
>>All of my SB220's, even with the grids grounded, only make
>>around 1200-1300 with100W drive on a known accuracy meter.
>
>I concur with W8JI here, as I have never seen more than 1300 watts
>from my SB220 using a Bird 43 and a peak reading modification to it,
>with my IC735 flat out at 100 Watts of drive. Maybe some people have
>high line voltage and get more? Or are measuring into a non-flat load
>(reactive)?
>
>73
>John
>K5PRO
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|