Say what? I thought GDOs only detected parallel resonances.
I was
taught that to check a series resonance one had to connect
the two
open ends together, thus making a parallel resonance.>>
Think a little bit about the circuit and where the GDO is
at. You aren't even measuring the grid at the socket pins.
You are measuring the socket pins.
It's like measuring your feedline in the shack with a GDO to
tell where the antenna connected at the other end is high
impedance or low impedance! Why would anyone do that?
73 Tom
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|