Hello everyone,
I have a 6N2 with an over voltage problem on the control circuit. The
voltage is 20 volts ac at the fuse when it should be 12. Looking at the
schematic the voltage is a leg from the transfomer to the fuse and then
rectified to 12vdc. Has anyone had this problem or have any ideas to rectify
the problem?
Any help would be apreciated.
_________________________________________________________________
Share your special moments by uploading 500 photos per month to Windows Live
Spaces
http://clk.atdmt.com/MSN/go/msnnkwsp0070000001msn/direct/01/?href=http://www.get.live.com/spaces/features
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|