What plate and screen voltages are you using?
And what class of operation?
Carl
KM1H
----- Original Message -----
From: "Andy GD0TEP" <andy@gd0tep.com>
To: "'amps'" <amps@contesting.com>
Sent: Wednesday, April 02, 2008 4:23 PM
Subject: [Amps] 4pr1000 bias question
> Hello group,
>
> My 50mhz 4pr1000 amplifier is 99.9% finished, but I'm stuck on one last
> item.
>
> Does anyone know what the operating bias should be? And, what should the
> cut
> off bias voltage be?
>
> The amplifier has been built using the SEK tetrode control boards, and has
> taken an absolute age to get to this stage, life and work keep getting in
> the way, hi.
>
> I'm keen to see this amplifier finished, but I really need some guidance
> on
> these two issues.
>
> Thanks in advance..
>
> 73
> Andy
> http://gd0tep.com
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|