What are you using to measure the input SWR?
73
Jim W7RY
On Mon, Jan 25, 2010 at 7:09 PM, Donald Fox <taurusshoguy@yahoo.com> wrote:
> Not sure why posts have been either slow or not appearing at all today.
>
> As one lister suggested, I substituted another coax jumper of a different
> length to rule out any issues there. No change.
>
> Also removed bottom access panel, and swapped input 1365pc relay with the
> output relay. No change.
>
> During this process, I did note that a few of the input circuit coils seem
> to be loose on their forms due to the glue aging and not holding their form
> properly.
> I am considering replacing the pair of .01 disk caps that couple rf from
> the input relay to the cathodes.
>
> Puzzling that all five bands input swr of 1.7 or higher. Makes me think the
> problem is a common issue to all bands. Possibly a cap somewhere along the
> chain that has gotten leaky.
>
> Don
>
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|