HI Peter,
Thanks for the info. Your adaptor looks very nice but does not look real
easy to build. I was thinking of something similar but with just a flat
plate and a short center pin.
73
Gary K4FMX
> -----Original Message-----
> From: Peter [mailto:pc2a@pi4cc.nl]
> Sent: Wednesday, January 27, 2010 1:25 AM
> To: garyschafer@comcast.net
> Cc: amps@contesting.com
> Subject: Re: [Amps] 3 1/8 EIA flange adaptor wanted
>
> Gary Schafer schreef:
> > I have a large Bird load with a 3 1/8 inch flange connector. I need an
> > adaptor to go to type N or other connector.
> >
> > Someone contacted me a while back that had a 1 5/8 to QC adaptor from
> a
> > smaller Bird load but I lost the info. I think I could use that to
> build the
> > adaptor I need.
> >
> > Thanks for any help
> > Gary K4FMX
> >
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
> I have homemade a 1 5/8 EIA to spinner 7/8"
> Its an easy job!
> http://www.pi4cc.nl/tech-info/tip/EIA-to-spinner/
>
> Peter
> PC2A
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|