Amps
[Top] [All Lists]

Re: [Amps] Supply question

To: "Michael J Talkington" <n8fwd@hotmail.com>, <amps@contesting.com>
Subject: Re: [Amps] Supply question
From: "Carl" <km1h@jeremy.mv.com>
Date: Tue, 19 Jul 2011 21:14:56 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
At that voltage the layout and construction takes a lot of TLC, even on 160. 
Id suggest 3200-3500V key down for long term reliability.

Carl
KM1H


----- Original Message ----- 
From: "Michael J Talkington" <n8fwd@hotmail.com>
To: <amps@contesting.com>
Sent: Tuesday, July 19, 2011 8:47 PM
Subject: [Amps] Supply question


>
> Hello,
> I am building a single band hf amp. I am using two 3-500Z tubes. The specs 
> for the tubes say
> 4000 Volts dc max. I keep hearing people volting these tubes in standby 
> above this voltage
> and when they transmit the voltage sags to 4000 vdc or a little below. Is 
> this bad for the tube?
> If I figure correctly 2800 volts ac full wave bridge and after filter caps 
> I should get  4032 volts dc
> 2800 X 1.44 am I correct? I will be bombarding you with questions cause I 
> want to do this right.
> Thanks Mike N8FWD
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1390 / Virus Database: 1518/3775 - Release Date: 07/19/11
> 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>