Amps
[Top] [All Lists]

Re: [Amps] preserving tubes

To: "David Kirkby" <david.kirkby@onetel.net>, Gary@ka1j.com
Subject: Re: [Amps] preserving tubes
From: ian@ifwtech.co.uk
Reply-to: gm3sek@ifwtech.co.uk
Date: Thu, 04 Oct 2012 09:16:04 +0100
List-post: <amps@contesting.com">mailto:amps@contesting.com>
If a tube has leakage to air, it is doomed anyhow, and storing it in a
vacuum can only delay the inevitable. Leakage will start right in
again when the tube is put into service.

 73 from Ian GM3SEK

----- Original Message -----
From: "David Kirkby" 
To:
Cc:
Sent:Wed, 3 Oct 2012 16:17:59 +0100
Subject:Re: [Amps] preserving tubes

 On 3 October 2012 06:20, Gary Smith  wrote:
 >
 > Is there any benefit to taking a ceramic tube on the shelf and
 > running it every so often and then returning it to the shelf to
 > archive it for a backup when needed? Or os it just as well to let
it
 > sit until needed?
 >
 > Gary
 > KA1J

 I have heard it is worth at least running the heaters up, but I
don't
 know. This is the sort of information Reid Brandon at Eimac could
have
 provided!

 I've often wondered if it is worth storing them in a vacuum - or as
 close to a vacuum as one can reasonably get. There's going to be
less
 diffusion of gases into the tube if the pressure outside is very
low.
 If you stored them at a pressure of 10% of atmospheric (VERY easy to
 achieve), then would it reduce the diffusion by a factor of 10?

 As you try to get to lower and lower pressures, the difficulty
 increases. I don't think you would need to go to the effort of
things
 like diffusion pumps.

 I'll lot you lot think (argue) about that one!

 Dave, G8WRB.
 _______________________________________________
 Amps mailing list
 Amps@contesting.com
 http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>