Peter did make some nice transformers. He was not the first to make tape wound
steel cores of course. I have them in an ancient Raytheon chassis that ran them
at 10 KHz for ultrasonics. Westinghouse made the strip material years ago too.
NWL, American Magnetics, SNC (used to), Basler Electric all still make good EI
laminated HV iron. As others have suggested names, I throw these in the pot as
more suggestions. Hams are not in dire straits since Harbach pulled out, only
those particular designs that Peter mastered will not be made (unless someone
else picks up the designs and the tooling). They will cost more as they have
more iron.
John
K5PRO
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|