Hi Bob,
You may find this link of interest:
http://qsl.net/wc6w/wc6wamps/index.html?fr63.html
73 & Good morning,
Marv WC6W
--------------------------------------------
On Thu, 9/3/15, nemo zilch <nemozilch@gmail.com> wrote:
Subject: [Amps] Regulated filament current
To: "amps@contesting.com" <amps@contesting.com>
Date: Thursday, September 3, 2015, 3:40 PM
I am slowly building an amp for hf
using a GS35B. For several reasons I
decided to feed the filaments with current regulated d.c. I
have the
circuit all designed and it regulates well. But the
question is what
current should I use? The spec sheet for the tubes
gives a range of
current to be expected when using the specified 12.6 volts
for the
filaments. I suppose that there is some variation in
filament current draw
from tube to tube. My inclination is to
adjust the current so that the
voltage across the tube is 12.6 volts. Does this seem
like the correct
thing to do?
Bob W4AOS
--
==========================================================
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|