Thanks ! I was looking to duplicate the original transformer - so taps for
120/240. The unit displays a anomaly where after 10 mins of operation, the
filament voltage drops and power from the tubes is lost. This seems
strange to me as I have only experienced transformer problems where it
either works or is dead, never a declining output. It has been suggested
the problem is the transformer - but I'm not so sure.
73
Greg VE7GPG
On Tue, Dec 22, 2015 at 7:41 AM, RMorris <robrk@nidhog.net> wrote:
> Look up the specs for the tube(s).... 5 v at 14 amps. What primary do you
> want... Taps for 120/240?
>
> http://www.umich.edu/~umarc/station/docs/3-500z.pdf
>
> Sent from my iPad
>
> On Dec 21, 2015, at 12:19, greg greene <greg.greene74@gmail.com> wrote:
>
> > Howdy folks
> > I'm trying to track down some info on the electrical specs of this
> > transformer to see if I can have a replacement made.
> > I've checked the manual - but do not see anything there that I can send
> the
> > repair outfit.
> >
> > Thanks !
> >
> > 73
> > Greg
> > VE7GPG
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|