On all this legal stuff.
Ok a ready to use amp cant legally have more than 15 db of gain.
Now how far down broken down that is, does an amp have to be, to be seen
as a "KIT"
From what I in the back of my mind remember that a "KIT" does not have
to abide by that law?
Or am I thinking of something else?
Joe WB9SBD
Sig
The Original Rolling Ball Clock
Idle Tyme
Idle-Tyme.com
http://www.idle-tyme.com
On 12/28/2016 9:04 AM, Peter Voelpel wrote:
A friend of mine, ex Telefunken design engineer, already built a class E amp
around 2x8 cheap SIHP10N40D transistors at less then 1 Euro each.
With 15W of drive output is 1200W.
Even without predistortion IMD3 is less then -30dB.
20 transistors will do your legal limit easily.
73
Peter, DJ7WW
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Manfred
Mornhinweg
- A high efficiency, high gain, deliberately non-linear, legal-limit
final stage. This might take the shape of a simple overdriven broadband
class AB stage, or perhaps a class E stage with tuned, band-switched
output tanks. It might use a single BLF188XR for about $150, or several
small switchmode MOSFETs for far less money.
To these hardware ingredients I would add some freely available
software, such as Pavel Denim's software for the Red Pitaya, plus
PowerSDR, using closed-loop, RF-feedback amplitude and phase
predistortion to linearize the amplifier. The software has this already
implemented.
The result would be a legal-limit, high efficiency, high performance,
compact, black-box HF transceiver to be used with a PC, for under $1000
total cost, if you are good at ordering surplus power supplies on eBay,
and such.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|