Thanks, Ed!
I have Jim's document (which is excellent), but I had never seen in it the
discussion of Fair Rite's use of "loss factor." I do, however, understand more
or less the losses that can be inuced by ferrites. K1FK sent me a short PDF
that explains where "loss factor" comes from and derives it, so I think I have
a better idea of what it is now.
73,
Kim N5OP
From: Ed K0iL <eddieedwards@centurylink.net>
To: rfi@contesting.com
Sent: Sunday, June 18, 2017 9:36 PM
Subject: Re: [RFI] Ferrite "Loss Factor @Frequency"
Except you didn't repeat the referral link.
So here's the page with all the links:
http://k9yc.com/publish.htm
Kim,
You might need to contact Fair-rite about their units and symbols they used.
Might be a faster route to the info you seek.
73, de ed -K0iL
-----Original Message-----
From: RFI [mailto:rfi-bounces@contesting.com] On Behalf Of Jim Brown
Sent: Sunday, June 18, 2017 9:04 PM
To: rfi@contesting.com
Subject: Re: [RFI] Ferrite "Loss Factor @Frequency"
Hi Kim,
Several times, I've referred questions like this to my RFI tutorial. I spent
years learning it, and months writing it up. I'm not going to repeat it here.
Instead, I'll repeat the referral.
73, Jim K9YC
On Sun,6/18/2017 6:20 PM, Kim Elmore wrote:
> As I was perusing type 31 material the Fair-Rite web site, I ran
> across a a material characteristic that is new to me: "Loss Factor @
> Frequency." For type 31 material, the units are in 10e-06 MHz, the
> symbol is Tan δ/ µi and it's 20 @ 0.01. How do I interpret this
> characteristic?
>
> Kim N5OP
>
>
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|