Using a simple PC based sound scope, the bursts of noise are indeed at a
frequency of 120 Hz, and looks just most of the power line arcing I have
tracked down over the years.
I will e-mail you a screen shot of scope capture.
On Fri, Dec 6, 2019 at 4:31 PM Eric Rosenberg <email@example.com>
> This may not have made it through the first time.
> My good friend Tm Shoppa, N3QE has run into a vexing RFI issue.
> He posed the following on the PVRC reflector, but is not on the RFI
> Please feel free to respond directly to Tim.
> Thanks & 73,
> Eric W3DQ
> ------ Forwarded Message ------
> From: "Tim Shoppa via PVRC"
> Sent: 12/6/2019 3:18:35 PM
> Subject: [PVRC] Help me identify my new RFI
> In the past week a brand new 24x7 noise source came out of nowhere.
> Clearly audible all over my neighborhood under every power line 540kHz -
> Recording made on 1.8MHz with receiver in 2400Hz bandwidth AM:
> Heard in AM, this not simple 120Hz impulse noise but shows strong
> 800Hz-1200Hz audio component interrupted at 120Hz. Waveform picture of
> the above audio sample shown below (not attached).
> Any ideas?
> Tim N3QE
> RFI mailing list
RFI mailing list