A much wider RF bandwidth is needed to be of much use in identifying
noise. Also a lot more dynamic range on the display, with lots of
averaging and the noise floor set to the bottom of the display. Notice
how the display is set in the P3 screen grabs in
http://k9yc.com/KillingRXNoiseVisalia.pdf
73, Jim K9YC
On 12/18/2019 5:59 PM, Larry Burke wrote:
It's pretty wideband. Scope is only showing 10 kHz both sides of where I
shot the video but I couldn't identify a specific center frequency for the
noise. It goes way farther than that in both directions.
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|