| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Omni C (Model 546C) front end... |
| From: | David Goncalves <davegoncalves@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 27 May 2010 14:48:23 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Unless somebody can pull it out from a scrap unit, you may have to rewind it. David Goncalves W1EUJ On Thu, May 27, 2010 at 2:07 PM, Dave Plews <djplews@comcast.net> wrote: > L1 (p/n 85097) needs replacement on the RF amp board (p/n 80460). Does > anyone have experience with this? What about parts? Ten Tec does not have > the L1 coil in stock and no replacement. Ideas? > Thanks > Dave W9TG > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec > > -- David Goncalves _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Ten-Tec 411 Centaur Amp Problem, Dr. Gerald N. Johnson |
|---|---|
| Next by Date: | Re: [TenTec] Ten-Tec 411 Centaur Amp Problem, Kris Merschrod |
| Previous by Thread: | [TenTec] Omni C (Model 546C) front end..., Dave Plews |
| Next by Thread: | Re: [TenTec] Omni C (Model 546C) front end..., Dr. Gerald N. Johnson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |