TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [TenTec] Ten-Tec 411 Centaur Amp Problem

from [Richards] [Permanent Link][Original]
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Ten-Tec 411 Centaur Amp Problem
From: Richards <jruing@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 27 May 2010 14:37:05 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com> 
What type of coax are you using as a jumper?

======================= K8JHR  ================================

On 5/27/2010 2:35 PM, Kris Merschrod wrote:
  .
> I have been using about 8" b/c the rig and amp are right next to each other.
>
==============================================================
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [TenTec] Ten-Tec 411 Centaur Amp Problem, Kris Merschrod
Next by Date:  Re: [TenTec] Ten-Tec 411 Centaur Amp Problem, Dr. Gerald N. Johnson
Previous by Thread:  Re: [TenTec] Ten-Tec 411 Centaur Amp Problem, Kris Merschrod
Next by Thread:  Re: [TenTec] Ten-Tec 411 Centaur Amp Problem, Kris Merschrod
Indexes:  [Date] [Thread] [Top] [All Lists]