| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] OMNI C Mixer or PTO problem |
| From: | scottsheppard@videotron.ca |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 20 Feb 2012 10:14:11 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I think I may be able to help on this having spent a LOT of time inside the OMNI...adjust the thumbwheel POT on the mixer/vfo board--it will ensure you are sending enough signal to stay on freq and send it to your counter...I am not near teh radio but I think it was referred to as adjustment level or something... let me know. scott VA3IED _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| Previous by Date: | Re: [TenTec] OMNI C Mixer or PTO problem, Rick - DJ0IP / NJ0IP |
|---|---|
| Next by Date: | [TenTec] Reputable dealer vs Hamfests, Bill Harris |
| Previous by Thread: | Re: [TenTec] OMNI C Mixer or PTO problem, Michael Silevitch |
| Next by Thread: | Re: [TenTec] OMNI C Mixer or PTO problem, Michael Silevitch |
| Indexes: | [Date] [Thread] [Top] [All Lists] |