| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] OMNI C Mixer or PTO problem |
| From: | scottsheppard@videotron.ca |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 20 Feb 2012 16:24:44 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
remember there are 3 pots there/// (maybe just 2 on the omni c) the one that actually turns in a direction parallel to the board should be it. i believe it is actually called the mixer balance...are you getting any signal at all on the rig regardless of display freq? scott _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] OMNI C Mixer or PTO problem, Michael Silevitch |
|---|---|
| Next by Date: | Re: [TenTec] OMNI C Mixer or PTO problem, Joe |
| Previous by Thread: | Re: [TenTec] OMNI C Mixer or PTO problem, Michael Silevitch |
| Next by Thread: | Re: [TenTec] OMNI C Mixer or PTO problem, Michael Silevitch |
| Indexes: | [Date] [Thread] [Top] [All Lists] |